No disponible.

Sparepart: HP Systemboard AMD K8 939 UATX, 380132-001

de HP

No disponible.
    Es adecuado para su  .
  • Introduzca su número de modelo más arriba para comprobar que sirve.
  • 380132-001

Información de producto

Detalles técnicos
Peso del producto980 g
Dimensiones del producto24,4 x 24,4 x 5,1 cm
Número de modelo del producto409643-001
Número de producto380132-001
Plataforma informáticaOrdenador sobremesa
Pilas / baterías incluidasNo
Pilas / baterías necesariasNo
Enfoque automáticoNo
Información adicional
Restricciones de envíoEste producto se puede enviar a España y a otros países seleccionados.
Producto en desde20 de diciembre de 2011

Descripción del producto

Kompatibel mit:

HP/Compaq Business Desktop - dx5150 MicroTower
HP/Compaq Business Desktop - dx5150 Small Form Factor

Preguntas y respuestas de los clientes

Opiniones de clientes

Todavía no hay opiniones de clientes en
5 estrellas
4 estrellas
3 estrellas
2 estrellas
1 estrella

Opiniones de clientes más útiles en (beta) 4.0 de un máximo de 5 estrellas 2 opiniones
3.0 de un máximo de 5 estrellas AS-IS you get what you paid for, but it works as good as new boards 8 de agosto de 2014
Por Hideki A. Ikeda - Publicado en
Compra verificada is where I got the pin-outs for FP1 (Front Panel) jumpers. The CMOS/BIOS wouldn't let me boot up until I disabled the CPU fan detection though the fan was functional. The center fan you see on this photo is missing on the board I've received (last few boards I've purchased usually come with this small fan on board), but this fan usually tend to die from overheating so do go purchase your own. I think this is the cause of BIOS complaining about the fan not functional.

Because it was a refurb, the board already had a CPU fan harness support glued (or stuck) on from the previous setups on the backside of the board. You cannot (probably) force it off so you'll have to work with what you have and hope that the CPU fan harness you own will fit into place.

Although this board is an ATX, its connectors at the back (USB's, Ethernet, onboard Video, etc) were slightly off to the left (about 1 cm or so) so I had to pop off the shielding which usually grounds these connectors of the chassis so that it'll fit on to the chassis.

I'm not sure if it was meant to or not, but the board I've purchased also came with an AMD CPU (AMD 3200, slower CPU than what I have) but I did not verify whether the CPU works or not since I had an AMD 3800 already for this board.

The board on the photo shows two PCIe and two PCI slots, but the board I got had an 1 AGP, 1 PCIe, and 2 PCI slots. Since my video card is an AGP, I was happy. Oddly, the BIOS only assumes PCIe based video card to be the primary or onboard to be the primary. Everything including the external USB (for front panel) have been verified except for the onboard audio. Only thing I have not yet verified is the onboard audio but so far, the board is as good as new.

On the separate note, the vendor was quick, got the board almost within few days!

On the note of onboard audio, according to you must short pins 5-6 and 9-10 on AUD_1 so that you can get the audio (headphone/Line-Out) from the rear panel to work correctly.
5.0 de un máximo de 5 estrellas Five Stars 27 de octubre de 2014
Por David A. Egloff - Publicado en
Compra verificada
great product,

Buscar productos similares por categoría